searchosearch CUNT asearchi
asearcht Cuntbrunette v Interior aesearcho Interior b
n Interior tsearcho BRUNETTE s BRUNETTE asearchs
n Cunt a Cunt e Brunette l Cunt d BRUNETTE & CUNT e Cunt c Cunt ;searchr Cuntbrunette gsearchp Interior rsearchnsearchr& CUNT e Cuntbrunette cl;& CUNT ac Cunt ; searchr%C7%C5%B1%BE%CE%E8%CE%DE%C2%EBgsearche Brunette t Brunette searchrsearchp CUNT r CUNT d Cuntbrunette b Interior searchCR CUNT a Cunt p CUNT iFXXXB.COMi BRUNETTE atsearcho BRUNETTE www.222aj.comfCHINESEGIRLFUCKEDp Interior T00 Cunt a Cunt d
R BRUNETTE 70 Interior wsearcht CUNT searchP6searcha Cuntbrunette d BRUNETTE 7searchpr0msearchr Cuntbrunette searchonaisearchi Interior gsearchebritish%20brunettet Cunt esearch searcht Cunt Psearch(search93 b
) Brunette o
searcht osearch Interior usearchan Cunt atsearchBs CUNT 194 b Brunette )searchwesearchesearchadsearchd BRUNETTE tsearch CUNT he BRUNETTE r Cunt dwww.sexinsex%21board%D1%C7%D6%DE%CE%DE%C2%EBolsearchbelsearched Interior a BRUNETTE t Cunt chmsearchnsearch s Cuntbrunette tsearch isearch 1ha p Cunt essearchnsearche ofsearchin%B9%FA%B2%FA%B7%F2%C6%DE%C2%B6%C1%B3%D5%E6%CA%B5%D7%D4%C5%C4egrase. Complexes containing either the uncleaved synapse, the cleaved intermediates with integrase bound covalently to the att sites, and integrase bound to the labelled substrate and products were observed by non-denaturing PAGE as described previously (27). These assays were performed using 1.5 ng of labelled probe (72 bp), 20 ng of the unlabelled fragment containing a ¡®partner¡¯ attachment site and 66 nM integrase in binding buffer. Unless otherwise stated, all reactions were incubated for a period of 2 h at 30¡ãC prior to electrophoresis on 5% non-denaturing polyacrylamide gels (200V, 5W for 2 h).
To detect the cleavage of the DNA fragments by integrase, reactions were set up as for the radioactive recombination assays but after incubation at 30¡ãC, reactions were heat inactivated (72¡ãC for 10 min) then incubated with 1µl of subtilisin A (Sigma 0.1 mg/ml in 1x binding buffer) for 15 min at 30¡ãC. Subtilisin was inactivated (72¡ãC for 10 min) and the reactions were loaded onto a 0.5x TBE, 5% non-denaturing polyacrylamide gel.
After electrophoresis gels were dried and exposed to a phosphorimager screen (Fuji) for 16 h and then scanned (Fuji FLA3200 phosphorimager). Quantification of radioactivity was performed using the AIDA software (Raytest, Straubenhardt, Germany).
Purification of integrase
Wild-type C31 and S12A integrase were purified as described previously (27). Integrase concentration was assayed using a method based on the dye-binding procedure of Bradford (45) employing the BioRad protein assay solution, and bovine serum albumin as a standard.
RESULTS
Identification of defective mutations in attB
The minimal attB site, according to Groth et al., (10) is 34 bp with the crossover 5'TT (abbreviated to XO) at the centre (Figure 1). Footprinting confirmed that integrase binds either side of the crossover site in all the attachment sites and, as integrase is a dimer in solution it probably binds as a dimer (29). Moreover, we have shown that integrase binds to attB and attP in a functionally symmetrical manner. Thus in order to maximize any phenotype arising from mutations in attB we generated a set of doubly mutated sites with base pair changes at symmetrical positions with respect to the crossover sequence. To aid in the description of the positions of mutations, the base pairs in the minimal attB and attP sites were annotated with either a negative number when they lie to the left of the crossover dinucleotide sequence (5'TT) i.e. B or P arm to use the terminology) or positive when it lies to the right of the crossover (B' or P' arm); the numbers count upwards as the position extends away from the crossover (Figure 1). Thus mutations in a double mutant involving the two base pairs adjacent to the crossover is at ¨C/+1 and mutations at the next position moving outwards are at ¨C/+2, etc. Mutations were chosen that would introduce sequence symmetry at the desired position. Thus each double mutant was designed to contain one of the four bases, A, T, C or G, at position ¨Cx on the B arm and at +x on the B' arm its complement, T, A, G or C, respectively, was inserted. The choice of mutation was made on the basis that the introduced bases had to be different from those present in both arms of attB and preferably also different to those seen in the pseudo-attB sites (Figure 1). For example, position 15 is a T in the B arm and a C in the B' arm and the pseudo-attB sites have a G in the B arm and a C or A in the B' arm. T-15C:C+15G and the T-15A:C+15T contain changes at ¨C/+15 on the B and the B' arm to base pairs that are different from both the wt and the pseudo-site sequences and should be functionally the same mutation in both arms. For most positions at least two mutant forms were made but for some sites (positions 4, 7, 16) only one option was available. Other positions where only a single mutant form was made are at 14, 17 and 18.
Except for mutations at positions ¨C/+3, ¨C/+8 and ¨C/+12 the activities of the double substituted attB sites was first assayed using annealed oligonucleotides. Oligonucleotides containing the double substitutions were purified by PAGE, annealed and used in an oligo-plasmid recombination assay (17). In this assay, a supercoiled plasmid containing attP was mixed with the oligonucleotide containing attB or one of the mutant forms and various concentrations of integrase. The extent of linearization of the attP plasmid indicated the extent of recombination and this was assayed after separation of the DNA in an agarose gel. A control reaction using the wild-type attB site was performed in every assay so that the activities could be compared under identical conditions. The lowest integrase concentration at which recombination could be observed was scored (Figure S1 and Table 1).
Many of the mutant attB sites showed little or only 2-fold change in activity compared to the wild-type site. These sites were changed at ¨C/+1, ¨C/+4, ¨C/+5, ¨C/+7, ¨C/+10, ¨C/+11 and ¨C/+13 (Table 1, Figure 1). The remaining mutants showed defective or partially defective activity ranging from 4-fold less active than wild type to apparently inactive. Oligos encoding sites C-2G:G+2C, C-2A:G+2T, G-6A:C+6T, (G-6T:C+6A, G-9T:C+9A, G-9A:C-9T, G-9C:C-9G, T-15C:C+15G, G-16T:G+15A and G-18C:A+18G were cloned into pGEM7 (Promega) so that the activities of the mutant attB sites could be verified by a standard recombination assay using both att sites residing on plasmids. Only one of the mutant attB sites that was partially defective (at position ¨C/+14) was not represented in the cloned mutant attB site collection; this site was instead subjected to single site substitutions (see later). T-15A:C+15T was not cloned as a plasmid containing another mutant at ¨C/+15 (T-15C:C+15G) with the same activity was quickly obtained. A plasmid encoding G-6C:C+6G was not obtained due to technical difficulties. Plasmids containing mutations in C-3T:G+3A, C-3G:G+3C, C-3A:G+3T, G-8T:C+8A, G-8C:G+8C, C-12A:G+12T and C-12T:G+12A were obtained by PCR mutagenesis as described in the Material and Methods section. The relative activities of the double substitution mutants were estimated compared to a standard reaction with wild-type attB (Table 1 and Figures 1 and 2). As for the oligo-plasmid assay the activity of each mutant site was scored as the concentration of integrase required to observe recombinants in an agarose gel stained with ethidium bromide (Table 1). The relative activities compared to the wild-type site are summarized graphically (Figure 1).
Three of the mutant attB sites were very defective for recombination and these contained substitutions at ¨C/+2, ¨C/+15 and ¨C/+16. In all cases no recombination was observed in either the oligo-plasmid or the standard assay using these double substituted attB sites (Figure 2 and Figure S1). Recombination was just detectable with attB containing substituted ¨C/+18 in the plasmid assay with 351 nM integrase (Figure 2). The low activity of the ¨C/+18 double mutant was surprising given that this position is outside the minimal attB site defined previously by Groth et al. (10). The nature of the mutations made small differences to activity in only a few mutants. The ¨C/+12 mutant containing the double transversion C-12A:G+12T was only just active with 87 nM integrase while the ¨C/+12 mutant containing the transitions C-12T:G+12A was active with 43 nM integrase (Figure 2). The G-6T:C+6A transversions had similar activity to wild-type attB but another ¨C/+6 mutant, containing transitions (G-6A:C+6T) was 2-to 4-fold less active than attB (Figure 2). yCunt Brunette Cuntbrunette CUNT BRUNETTE By Interior Cunt Brunette Sequences in attB that affect the ability of C integrase to synapse and to activate DNA cleavage--《核酸研究医学期刊》--医学期刊频道--首席医学网q o r Sunprono. 0 eCunt Brunette Cuntbrunette CUNT BRUNETTE By Interior Cunt Brunette Sequences in attB that affect the ability of C integrase to synapse and to activate DNA cleavage--《核酸研究医学期刊》--医学期刊频道--首席医学网f m 1 Cunt Brunette Cunt Brunette YELL%20%A1%AB%A5%A8%A9%60%A5%EB%A1%AB%20%CF%C2%D4%D8